Innokin Coils

Innokin Endura T18 replacement coils are available in 1.5ohm resistance to give a true MTL style vape when used with the Innokin Endura T18 II pen vape kit.

A vape coil usually lasts about 7–10 days, but that depends on how much you vape and what kind of e-liquid you use. If you’re into sweet flavours, just know they can burn out your coils faster.

If you're using the Innokin Endura T18 II, the only compatible coils for this device are the Innokin Endura Prism T18E coils. Despite looking similar, no other Endura coils will be compatible with the T18 II.

For MTL (Mouth-to-Lung) vaping with 50/50 e-liquids, select a coil rated 0.8 ohms or above.

For RDTL (Restricted Direct-to-Lung) vaping, go with coils in the 0.5–0.7 ohm range; these can handle High VG e-liquids if your device operates at higher wattages.

For DTL (Direct-to-Lung) vaping, use coils 0.4 ohms or below. This works best with High VG e-liquids, as the higher wattage properly heats the thicker liquid, creating large clouds.

If you're using the Innokin Endura T18 II, this device uses replacement coils. To prime them, just dab a small amount of e-liquid on the exposed cotton parts of the coil which will then begin soaking in. And once the coil is installed in the device, top up your tank with e-liquid and leave it to stand for around 5 minutes before using and this will properly prime your coil.

If using any of the Klypse devices, these use replacement Klypse pods that have the coils integrated in each pod. All you need to do to prime these coils is top up your vape pods with your e-liquid of choice and leave it to absorb into the cotton of the coil for around 5-10 minutes and then you'll be able to vape with your Klypse device!